Use to mount our Rubber Parking Stoppers to concrete floors. Made from 304 stainless steel and will not rust over time, even in outdoor parking settings. Fits our rubber parking stoppers perfectly.
To Install:
1.Position rubber stoppers on floor and mark mounting holes on the concrete floor.
2.Using a 12mm diameter masonry bit, drill approximately 8 to 10cm deep into the concrete floor, 2 holes per rubber stopper.
3.Drive the wedge anchor slowly into the hole with a hammer (threaded part sticking out of the ground). Make sure to leave at least 5 to 7cm of the threaded part out.
4.Lay rubber stopper on the concrete anchors, making sure holes are aligned well. Insert washers, followed by the 19mm nut.
5.Tighten nuts well and you're all done!
Price::
PhP320 per pair if bought alone.
PhP250 per pair if bought with our Rubber Parking Stoppers.