Use to mount our Parking Barriers to concrete floors. Made from 304 stainless steel and will not rust over time, even in outdoor parking settings. Fits our steel parking barriers perfectly.

To Install:

1.Position parking barrier on floor and mark mounting holes on the concrete floor.

2. Using a 12mm diameter masonry bit, drill approximately 8 to 8.5cm deep into the concrete floor, 4 holes per parking barrier.

3. Drive the wedge anchor slowly into the hole with a hammer (threaded part sticking out of the ground). Make sure to leave at least 1.5 to 2cm of the threaded part out.

Lay parking barrier on the concrete anchors, making sure holes are aligned well. Insert washers, followed by the 19mm nut.

5.Tighten nuts well and you're all done!


PhP160 per piece if bought alone.

PhP125 per piece if bought with our Parking Barriers